Step 2: "The Fit" - Basic Fulcrum Grip
The
PaGu Process* ™
Step
2: "The
Fit"
Here
are some general guidelines that will help you select a PaGu Baton.
You will need a tape measure or ruler for the following
steps will guide you
through "The PaGu Process":
|
|
Length of Handle:
Measure your
thumb, on the
back side of your hand, from the top of the base knuckle to the tip (of
the thumb, not the nail). This measurement will generally be between 2”
& 3”. This will be the length of your handle.
Width of Handle:
Measure the width of
your middle thumb knuckle (the one below the nail). This will generally
be between 1/2'”- 1”. This will be the widest diameter of a handle you
should choose.
Pick
Baton handle below that
best fits your hand. After you select a handle, the final step will be
to balance your baton.
*
Patent Pending
-Cocobolo copy_thumbnail.jpg)
_thumbnail.jpg)
_thumbnail.jpg)
_thumbnail.jpg)
 (3553)_thumbnail.jpg)
_thumbnail.jpg)
 (3361)_thumbnail.jpg)
_thumbnail.jpg)
Step
3: "The Balance"
Here
are some general guidelines that will help you select a PaGuBaton.
You will need a tape measure or ruler for the next steps. The following
steps will guide you
through which batons fits your anatomy:
|
Length
of
Stick: With your conducting hand palm
up, toward the ceiling, and your conducting arm at a perfect 90 degree
angle, measure your entire bare forearm to the center of your palm.
This measurement will be somewhere between 11” to 13” depending on your
height. This is your stick length from the tip to your pinch point.
Your baton will balance at this point.